Doors That Stick, Sag or Won't Latch
Most sticking or sagging interior doors are fixed in an hour or less by tightening hinges, moving the strike or trimming the edge: $85 to $132.50 before parts with Chagrin Valley Handyman. Lever handles, smart locks and closet door tracks bill at $85/hr after the first 30 minutes. Text a photo of the door's edge for a price.
Prefer a form? Request a visit. Jason calls or texts to set the time.
What does it cost?
Rate: $85/hr after the first 30 minutes. Estimates are before parts.
3 hours for $295, plus parts, and shorter jobs pay the normal hourly price, whichever is less. Time past 3 hours bills at each trade's hourly rate in 30-minute steps. Plus parts, which we price before we install them. The $5 shop-supplies fee is included.
| Job | Typical time | Estimate, before parts |
|---|---|---|
| Fix a sticking or sagging door | up to 1 hr | $85 – $132.50 |
Priced from your photo, at the same rates:
- Lever handles in place of round knobs
- A smart lock or keypad deadbolt you bought
- Bifold and sliding closet door tracks
- Trim a door to clear a new floor
- Cabinet hinges and drawer slides
- Storm door closer, latch or chain
- Garage door keypad, remote or safety sensors
- Garage door bottom seal and weatherstripping
Every charge, stated up front: the $85 service call covers the first 30 minutes; time after that is billed in 30-minute steps; visits over 30 minutes add $5 for shop supplies; parts are at cost, plus 25% handling when we buy them; and a second visit is a $50 trip charge. See the handyman cost guide for worked examples.
Why doors stick in summer and winter
Wood takes on moisture in humid months and gives it up once the heat runs, so a door that closed fine in March can bind in August. Most sticking starts at the top hinge: its screws work loose and the door drops toward the latch side.
Long screws driven through the hinge into the framing behind the jamb usually pull it back. If that isn't enough, we move the strike or take a little off the edge.
Trimming a door for new flooring
New flooring or a thicker rug can leave a door dragging. We take the door off, cut the bottom clean against a guide, seal the cut edge so it doesn't swell, and hang it back.
Older painted doors
Trimming or sanding a painted door in a house built before 1978 disturbs old paint, which can contain lead. We keep it within 6 square feet of painted surface per room, with plastic down and a careful clean-up. Anything more becomes a different job, and we say so first.
Locks, levers and closet doors
Levers are easier than round knobs with full hands or a sore wrist. We swap them, set smart locks and keypad deadbolts you have bought, and reset bifold and sliding closet doors that keep jumping their tracks.
Small garage door jobs
We set up keypads and remotes, realign the safety sensors when the door won't close, replace the bottom seal and weatherstripping, and swap worn rollers. Springs and lift cables hold the door's full weight under tension, so we leave those to a garage door specialist.
What can stop or change the job
- A frame out of square because the wall itself has moved. That becomes a framing repair.
- A solid door so swollen it needs more than trimming.
- A pre-1978 painted door where the fix would disturb more than 6 square feet of paint.
- A smart lock that won't fit the door's existing holes without new drilling.
- Garage door springs or lift cables. Those go to a garage door specialist.
Watch Jason do the job
What you can count on
- Licensed general contractor. We do most of the work ourselves and bring in a licensed electrician or plumber where a job calls for it.
- Insured. We send a certificate of insurance on request.
- You deal with Jason. From the first text back to the final bill, Jason is the person you talk to.
- A written price before work starts. You see the price and approve it before anything is scheduled. Any change is written down first.
- 7-day labor callback. If our workmanship fails within 7 days, we come back and redo it free.
- Real photos. Every job photo we post is from our own work. No stock photos.
Add to the same visit
More: every small job we do · Home Repairs · Handyman Services
Have a bigger project? We take on 2–3 day jobs too, like carpentry, framing and remodel work. Send photos for a free video estimate. Request a free video estimate.
Questions
How much does it cost to fix a door that won't close?
Most take an hour or less: $85 to $132.50 before parts. The $85 service call covers the first 30 minutes, then $85/hr. Several doors on one visit share the service call, so send them all in one text.
Can you cut down a door for new flooring?
Yes. We take the door off its hinges, measure from the new floor, cut the bottom straight, seal the raw edge and hang it back. Hollow doors sometimes need the bottom rail glued back in after a deep cut, which we do on the same visit.
Can you install a smart lock I bought?
Yes, on a door already drilled for a deadbolt; most smart locks fit the standard hole. If yours needs a new bore or a deeper latch, we tell you before we drill. We stay while you pair it to your phone and try it.
What's the difference between a contractor and a handyman?
A handyman takes small repairs across trades. A general contractor runs larger projects and brings in licensed trades. Chagrin Valley Handyman is a licensed general contractor that specializes in small jobs, so the same company can fix a sticking door today and take on a remodel later.